ETRX2-PA - Power Amplified Mesh Networking Module

  Download - Telegesis ETRX2-PA product overview

The Telegesis ETRX2-PA offers boosted output power whilst being a drop in replacement for the standard ETRX2. Care was taken to retain the low deep sleep current to make this module ideally suited for battery operated end devices with the lowest transmit current in its class.

Based on the Ember EM250 single chip ZigBee solution utilizing EmberZNet 2.xx meshing technology, it has been designed for fast integration into any device without the need for RF experience and expertise.

Unlike many other module command layers the Telegesis AT-Style command set fully mirrors the functionality of the EmberZNet mesh networking stack.  With the ETRX2 module there is therefore no requirement for any embedded firmware expertise when engineering your mesh networking solution.

Module Features

• Small form factor, SMT module 37.75 x  20.5mm
• Optional board-to-board or board-to-cable connector
• 3 antenna options: Integrated ceramic antenna, Hirose U.FL coaxial connector or single port 50W pad
• XAP2b microcontroller with non-intrusive debug interface (SIF)
• 128k flash and 5kbytes of SRAM
• UART interface with DMA, optional software support   for hardware I2C and SPI
• Wide supply voltage range (2.8 to 3.6V)
• Module ships with standard Telegesis AT-style software interface based on the mesh stack of EmberZNet 2.xx.
• Can act as an End Device, Router or Coordinator
• 12 general-purpose I/O lines and 2 analogue inputs (all 17 GPIOs of the EM250 are accessible)
• Supports 4 different power modes for extended battery life
• Current consumption below 2uA in deep sleep mode with self wakeup
• Firmware upgrades via RS232 or over the air (password protected)
• Hardware supported encryption (AES-128)
• Tested for CE and FCC compliance with integrated antenna plus a selection of external antenna, FCC modular approval
• Operating temperature range: -40°C to +85°C
• Future Options: On board, low power voltage regulator, DC/DC regulator and watch crystal

ETRX2-PA - Actual size - 37.75 x 20.45mm

ETRX2-PA	ETRX2HR-PA   Hirose connector in place of integrated antenna

Radio Features

• Based on the Ember EM250 single chip ZigBee / IEEE802.15.4 solution
• 2.4GHz ISM Band
• 250kbit/s over the air data rate – NB actual usable data throughput with ZigBee is 20kbps
• 16 channels (802.15.4 Channel 11 to 26)
• +18dBm output power (<100mA)
• High sensitivity of -97dBm typ. At 1% packet error rate
• Hardware acceleration for IEEE 802.15.4 compliant transmissions

At Power-up the last configuration is loaded from S-Registers. This can eliminate the need for an additional Host Controller.

Request a quotation

  Download - Telegesis ETRX2-PA product overview

Top of Page