How to build a PC application using the Telegesis AT Command Set
The command line of the ETRX357 can be accessed using any terminal software program such as HyperTerminal.
To speed up evaluation Telegesis provides its own Terminal Application Software program which allows enhanced functionality especially suited to the ETRX357 modules.
Example software frontend application and source code
To further reduce time spent developing a frontend application, Telegesis has written a very simple application in Visual C++ using Visual Studio 2008 to be used with the Development board and ETRX357 module supplied in the Telegesis ETRX3DVK kit.The source code can be downloaded for free from our website.
This Demo Terminal Application only works for Telegesis R300 firmware onwards – based on ZigBee Pro.It is not suitable for 64 bit computers.
For instructions on how to use the AT-Commands read the AT command Manual for your version of the R3xx firmware.
Picture below showing all AT Commands available in the Demo Application
Buttons and equivalent AT Commands are:-
Info = ATI
Enter Bootloader = AT+BLOAD
Send BCAST = AT+BCAST:00,Telegesis Demo Terminal Application
Read Register S1A = ATS1A?